1.800.925.1510 1.800.544.8512 1.800.861.562 +43.720.902383 Flexxifinger® Brochure     |
Crop Lifters

Crop Lifters

Original MidCut™ Crop Lifter
Videos & Guides

The Flexxifinger® MidCut™ lifter is designed to harvest taller, heavier crops that are lying on the ground due to weather or insect damage. It has a replaceable nylon finger as well as a replaceable steel skid shoe. It allows the operator to pick up low-lying crop, leaving taller stubble approximately 5" - 6.5"/127mm – 165mm high, which will help trap snow and prevent erosion from wind and water. It is not recommended for use in pulse crops, beans or other fragile crops.


Custom fit

The Flexxifinger® MidCut™ Crop Lifter™ is offered in two models (N for longer guard lengths and J for shorter guard lengths) which makes it compatible with virtually every guard system on the market.  Please refer to our fitting chart for which size is compatible with your make and model of header and/or guard system.

QD™ Compatible

Flexxifinger® uses the same patented QD™ technology on all its lifters, which makes it possible to quickly interchange different lifters on the same header without the need for removing the guard bolt each time.


Crop type: cereals, forage, canola, mustard

Generally, the recommended spacing is one lifter per foot across the header. Harvesting some row or bedded crops, where lifters mounted to the row or a combination of different Flexxifinger® lifters to maximize recovery have proven beneficial.

** Some or all of these components are made of steel, therefore care must be exercised by the combine operator to minimize possible damage to the header/ combine.**

Optional Accessories

32310 Carriage Bolt

This Carriage bolt is for select headers that have a poly skid plate held on by a 7/16” (11mm) carriage step bolt from under the header, which tapers to 10mm in order to mount the QD™ nut assembly. 

32312 Carriage Bolt

This Carriage bolt is for a header that uses a 7/16” (11mm) carriage bolt from under the header, which tapers to 10mm in order to mount the QD™ nut assembly. 

32314 Carriage Bolt

This Carriage bolt is used on a header that has a 10mm guard bolt from under the header, in order to mount the QD™ nut assembly.  

40090 Off-set Bracket

On headers that have 4”(100mm) spacing between the guards, there will be instances where the guard bolts do not line up with the guard point, making the installation of a lifter at specific intervals impossible. Flexxifinger® has engineered a patented bracket, to position a lifter on a guard tip that does not align with a bolt. This allows users to place Flexxifinger® lifters at intervals other than once every 12” (304mm).

See if this product is right for you


Comparable Products